DSI Dive Control System 2-A
DCS Dive Control System-2A (400-020) is a lightweight, portable control box for use in surface supplied air diving operations. The DCS-2A controls the diver’s air supply, communications and also monitors the diver’s depth. It allows two divers clear push-to-talk (two wire) or round robin (four wire) communications.
The air supply can either be from a low pressure compressor or high-pressure cylinders. An adjustable first stage regulator in the DCS-2A reduces the high-pressure air and supplies low pressure through the umbilical to the diver’s breathing system. High pressure yokes permit U.S. standard scuba cylinders to be used. Low pressure air supply fittings allow for a compressor to be used as the primary air source, when available. A complete pneumo system with dual reading gauges (both US Standard and Metric) is provided for each divers air, as well as a shut-off/bleed system that uses two high-pressure feed lines which allow the changing of used cylinders without interruption of the diving operation. Optional shut off valves allow the isolation of one diver’s air supply from the other.
The advanced communications system allows for either two-wire (push-to-talk) or four wire (round robin/open circuit) capabilities. It features a rechargeable gel battery for up to 20 hours of continuous operation. Gel batteries do not have a “memory”, allowing for complete charge after each use. Unlike Nicad batteries, Gel batteries do not have to be run down completely before charging. Boat or car batteries can also be externally connected if desired. Each dive can be tape recorded through a dedicated jack and there is a remote speaker jack. Cross talk capability for diver to diver communications is standard. Communications options include a headset with boom mic as well as a wireless tender remote.
The high impact polyethylene plastic DCS-2A case will not crack or chip. Double wall construction and extra thick corners ensure exceptional strength and a long work life in a lightweight case. An O-ring seal protects hardware from moisture when the case is closed. Latches are all stainless steel for maximum life.
Features
| Outer Dimensions | |
| Length | 21” |
| Width | 17.5” |
| Height | 12” |
| Weight | 54 lbs |
| Shipping Weight | 60 lbs |
| Maximum Life Support Depth | 240 ft. of sea water |
| High Pressure Supply Pressure Maximum | 3000 lbs per square inch |
| Low Pressure Supply Pressure Maximum | 225 lbs per square inch |
| Relief Valve | set at 300 psi |
| Pneumofathometer Range | 0-250 ft of sea water (0-78 meters) |
| Communicator | 4 wire system - can use 2 wire mode |
| Communicator Req. Response | 600 to 12000 Hz |
| Remote Operation Capability w/ optional Unit | |
| Direct Recording Capability | |
| Battery Type | Rechargeable Gel Cel, 12 volt system |
| Battery Performance | 20 hours of continuous use between charges in 4 wire mode |
| Regulator Output | 40 SCFAI at 2500 psi supply pressure w/ 150 psi delivery pressure |
Ordering Information
* You MUSTfill in ALL fields to recieve a response. Thank You*
Air / HEO2 Consoles Main Index
Home | Product Index | Email
© 2003 Aqua Air Industries, Inc. - All Rights Reserved
AQUA AIR INDUSTRIES, INC.
639 Manhattan Blvd.
Harvey, Louisiana 70058 USA
| Phone | (504) 362-8124 |
| Fax | (504) 362-3600 |
| sales@aquaairind.com |