ANDEROLâ
500 Synthetic Compressor
Oil (ISO 100)
ANDEROL®
500 is an ISO 100 diester-based lubricant designed to provide high temperature
and long-term lubrication with minimal deposit formation.
Fewer oil changes
Lower oil consumption
Reduces compressor maintenance
Eliminates lacquering and deposits
Greatly reduces fire and explosion hazard
Reduces energy consumption
Separates water condensate rapidly
Applications
Cylinder
and crankcase lubrication for reciprocating compressors and vacuum pumps for the
following gases:
Air
Butadiene
Benzene
Carbon Monoxide
Carbon
Dioxide (dry) Furnace (crack) gas
EthyleneSulfur
Hexafluoride
Helium
Natural
gas
Methane
Propane
ANDEROL® 500 may also be considered for other applications requiring an oxidation resistant lubricant.
Nominal Operating Range is -15°C to 210°C.
ANDEROL synthetic lubricants are the only long-life synthetic lubricants with over 20 years of successful performance. They are field tested, approved or recommended by major compressor manufacturers. Should you have any questions regarding the suitability of ANDEROL® 500 compressor lubricant for a specific manufacturer's model compressor, please check with your ANDEROL lubricant supplier or contact Anderol Company.
COMPATIBILITY
- The following seals, paints, and plastics are recommended for use in contact
with Anderol Company Synthetic Lubricants.
Materials not recommended are also shown.
For more information on other materials, see our "Compatibility
Guide."
RECOMMENDED
- Viton, High Nitrile Buna N, Teflon, Epoxy Paint, Oil-Resistant Alkyd, Nylon,
Delrin, Celcon, PBT
NOT
RECOMMENDED - Neoprene, SBR Rubber, Low Nitrile Buna N, Acrylic Paint, Lacquer,
Polystyrene, PVC, ABS
|
PROPERTY |
TEST
METHOD |
MIN |
MAX |
TYPICAL* |
|
Viscosity @ 40°C, cSt Viscosity
@ 100°C, cSt Pour
Point, °C Flash
Point, °C Specific Gravity, 15.6°C |
ASTM D 445 ASTM
D 445 ASTM
D 97 ASTM
D 92 ASTM D 1298 |
95 9.9 - 240 0.955 |
110 11.5 -30 - 0.970 |
98.8 10.4 -35 250 0.960 |
|
PROPERTY |
TEST
METHOD |
TYPICAL
RESULTS* |
|
Auto ignition Temperature, °C Conradson
Carbon Residue, % Evaporation,
22 hrs @ 99°C, % Copper
Strip Corrosion, 3 hrs @ 100°C Demulsibility
@ 54°C, ml
oil/water/emulsion (minutes) Four-Ball Wear, 1200 rpm, 75°C, 40 kg, 1 hr, mm |
ASTM E 659 ASTM
D 189 ASTM
D 972 ASTM
D 130 ASTM
D 1401 ASTM D 4172 |
410 0.02 <1.0 1a 39/38/3 (<60) 0.8 |
*
Values for typical results are for information only and can vary; not
specifications.
Home | Product Index | Email
© 2003 Aqua Air Industries, Inc. - All Rights Reserved
AQUA AIR INDUSTRIES, INC.
639 Manhattan Blvd.
Harvey, Louisiana 70058 USA
| Phone | (504) 362-8124 |
| Fax | (504) 362-3600 |
| sales@aquaairind.com |